Broken GPIO 0 on a DE10 Nano Board

For topics which do not fit in other specific forums.
asturur
Posts: 1
Joined: Thu May 27, 2021 1:20 pm

Broken GPIO 0 on a DE10 Nano Board

Unread post by asturur »

So I have been through buying my first DE10 nano board and i got a broken one.

I was proposed to ship it to Terasic for fixing but at the end Mouser electronic was kind enough to ship me a new board.

I shipped the board to Terasic anyway to see if it could be fixed and the answer is no.
They say a pin on my GPIO 0 pins has a low impedence, the FPGA has been damaged and requires to be swapped.

Now i ll get my board back ( broken ) and i can still use it for genesis and something else.

I was wondering if is possible to reprogram the main codebase to use the ram on the other GPIO 1 pin set rather than the original GPIO 0.

Someone knows if something like this is even possible or there are hardware limitation that make it unfeasible?
Post Reply