Only official MiSTer add-on boards!
- Posts: 85
- Joined: Sun May 24, 2020 7:28 pm
- Location: United Kingdom
- Been thanked: 31 times
When I first used 7TCN chips with the v2.5 memory modules, I did test internal air temperatures in the small range of cases available at time, it was during the time I began prototyping the acrylic case I sell. I even went to the point of stress testing inside an acrylic box, with no heatsink or fan on the DE10 Nano, all then wrapped tight in a polythene bag! I did not experience any issues at all with my stress testing setup so a passively cooled case from MisterAddons would even with 30C ambient air surprise me if it got anywhere close to that high of an internal air temperature.
MiSTer FPGA Add-On Boards : UK based, low cost worldwide shipping.