What's the best/cleanest way to add pull-up resistors to user port on I/O board v5.5?

[sofakng]

Does anybody have any suggestions or pictures of the best/cleanest way to add the pull-up resistors to the user port on the I/O board v5.5?

I know you just need to add 10k resistors from VCC to each user port pin, but I'm wondering where it's best to place them on the board?

Please let me know if I did it correctly:

xbYNEDR.jpg (419.38 KiB) Viewed 1324 times

P7 - Pin 1, 2, 4, 5, 6, 7, 8 -> 10k ohm resistors -> GPIO 29 (VCC, 3.3v)