Lights on the MiSTer do not light up

MorkMikael
Posts: 96
Joined: Thu Jun 04, 2020 9:01 pm
Has thanked: 16 times
Been thanked: 19 times

Lights on the MiSTer do not light up

Unread post by MorkMikael »

When do the lights on the MiSTer light up mine is all ways dark its the same with the red light (+FAN ) near j2. got the IO Board XL v6.1 with Noctua fan. Using the power brick that was with the de-10 Board. Do i need a better power brick or is the a jumper on the IO Board i'm missing.
User avatar
barfood
Posts: 95
Joined: Thu Jun 18, 2020 6:55 pm
Location: new user: felleg
Has thanked: 87 times
Been thanked: 18 times
Contact:

Re: Lights on the MiSTer do not light up

Unread post by barfood »

I found my LEDs would not light up when the SD card was not inserted. Is your MiSTer working fine while the LEDs are not turning on?
User avatar
Nat
Posts: 125
Joined: Sun May 24, 2020 7:28 pm
Location: United Kingdom
Has thanked: 8 times
Been thanked: 70 times
Contact:

Re: Lights on the MiSTer do not light up

Unread post by Nat »

Check the jumper cap is present on the two pin header marked P3, if your IO board builder cut the trace on the board, this needs to be present to enable the three status LEDs.
MiSTer FPGA Add-On Boards : UK based, low cost worldwide shipping.
https://MiSTerFPGA.co.uk/
Post Reply