Use LaserBear vesa iPad case w/ RetroFrog RoTate

Showcase builds, discuss cases, embedding MiSTer into existing computer cases.
User avatar
hellbent
Posts: 58
Joined: Tue Nov 09, 2021 9:19 pm
Has thanked: 22 times
Been thanked: 73 times
Contact:

Use LaserBear vesa iPad case w/ RetroFrog RoTate

Unread post by hellbent »

I had a kickstarter RoTate stand but never used my switch in tate mode. I had a laser bear iPad case for my mister but just had it propped on a wire stand. Why not smash them together?

Edited the stand stl up on printables to make it taller. Used switch mount stl to create a new vesa adapter plate to interface the stand with the vesa case.

extended_upright.jpeg
laser_bear_vesa_plate_adapter.jpeg
IMG_2117.jpeg
IMG_2118.jpeg
IMG_2121.jpeg
IMG_2120.jpeg

Stand needs a heat-set insert in the bottom for the thumbscrew and you’ll also need some m4 bolts for the vesa adapter. I had flathead socket cap screws so that’s what I used.

modified_upright_and_vesa_adapter.7z
You do not have the required permissions to view the files attached to this post.

@h3llb3nt.bsky.social

User avatar
LamerDeluxe
Top Contributor
Posts: 1141
Joined: Sun May 24, 2020 10:25 pm
Has thanked: 772 times
Been thanked: 254 times

Re: Use LaserBear vesa iPad case w/ RetroFrog RoTate

Unread post by LamerDeluxe »

Good job! That is a neat looking solution.

stepea
Posts: 14
Joined: Tue Sep 08, 2020 8:38 pm

Re: Use LaserBear vesa iPad case w/ RetroFrog RoTate

Unread post by stepea »

I bought a laserbear case and then bought ulanzi ipad VIJIM P001 stand hoping that both would fit - so I'm looking for an adaptor to merge the two or maybe a replacement stand.

Post Reply