Page 1 of 1

MiSTer.ini custom video_mode (modeline) to natively support a 480x272@60 LCD display possible?

Posted: Mon Aug 31, 2020 11:15 pm
by javierrodas
Hi, after reading this post https://www.atari-forum.com/viewtopic.php?t=35169 I'm wondering if it would be possible to natively support a 480x272px LCD at 60Hz, similar to the PSP display, to display for instance the GB, NES or SNES cores.

Using this page https://arachnoid.com/modelines/ I can generate the following modeline, which PixelClock is 9.2MHz:

Code: Select all

# 480x272 @ 60.00 Hz (GTF) hsync: 16.92 kHz; pclk: 9.20 MHz
Modeline "480x272_60.00" 9.20 480 472 512 544 272 273 276 282 -HSync +Vsync
But at the first URL it says the MiSTer minimal frequency starts at 20MHz.

Do you think this modeline (transformed into the "video_mode" line as explained in first URL) could works in the mister.ini when using the RAW RGB Digital_6+6+6bit VIDEO and HSYNC+VSYNC SIGNALS of the GPIO1 of DE10-Nano (usually connected to the IOBoard-analog)?. I mean, the GB, NES and SNES cores native resolutions are 160x144px, 256x240px and 256x224px respectively, and at ~60Hz their PixelClocks are <5MHz, that is, always slower than 20MHz... So, does the video_mode in mister.ini only affect the HDMI output, or also the RAW RGB Digital Video being "scaled" (or not) though the DE10-Nano GPIO1 port?.

On the other side, do you think it would be possible to modify the Cores to output the PixelClock signal out of a GPIO of the FPGA (for instance using any of the secondary SD-Card GPIOs in GPIO1), to feed this kind of 480x272@60 LCD display (which needs this PixelClock input signal to work, in addition to the 6-bits R-G-B, VSYNC and HSYNC signals already available at the DE10-Nano GPIO1 port)?.

Thanks!.

Re: MiSTer.ini custom video_mode (modeline) to natively support a 480x272@60 LCD display possible?

Posted: Sat Sep 05, 2020 2:06 am
by javierrodas
Has anyone at least tried to use a custom video_mode (modeline) to support a smaller than 480p resolution monitor to the IOBoard via the VGA port?.

In https://ini.misterkun.io/ I do not see any default resolution lower than 480p and I was wondering why...