MiSTer FPGA Forum

Hi, I was wondering if there was a spot that identified the parts list for the new 6.1 boards. The wiki has a detailed list for v5.5 and the PDF doesnt clearly identify which parts I would need to order online.

Just looking for help

Thanks!

Get Altium Viewer (https://www.altium.com/altium-designer-viewer) (it's free with some caveats as a trial) and open the design files, there is a BOM in there I believe.

When I was looking at this that's the route I went down, and I found a lot more info there.

Not everything is updated in the lists, like the mini TOSlink plug, the 1206 array resistors etc..

I don't have a BOM since I ordered from many different places but most of the board parts are HERE. But I can help you with some parts:
For those resistor arrays you need something like THIS. 1206, 8pins, 4 resistors. Normal ones are 0805
Capacitors are standard 0805 (small) and THOSE x3 (big guys)
BC847
That toslink thingy
SOG Switch

and the Swiches

Rest is pretty standard stuff. Hope this helps

You know whats funny, I didnt realize that the LED behind that 3.5mm jack was actually the toslink LED.

Thats some pretty awesome Wizardry

Thanks!

Can somebody help me with the MicroSD holder's reference ? I can't figure out which one is used and they all have different footprint.

This one is OK :
https://lcsc.com/product-detail/Card-So ... 66620.html

Did any of you produce a list of parts from the PDF listed above? MAPPY's post was very helpful, but I'm having a hard time picking out the individual components from the PDF that required to put the board together. I would be more than happy to contribute a full BOM, in a simplified list because I'm no expert, once I have figured out everything and found reliable sources.

Does anyone know which tantalum capacitors will work for C6, C11, and C12? I know the value is 100uF and package is 2312 but that's all the info I have. I found these https://www.mouser.com/ProductDetail/Ky ... 2HcA%3D%3D not sure if they will work.

breakbeatscientist wrote: ↑Wed Jan 12, 2022 10:14 pm Does anyone know which tantalum capacitors will work for C6, C11, and C12? I know the value is 100uF and package is 2312 but that's all the info I have. I found these https://www.mouser.com/ProductDetail/Ky ... 2HcA%3D%3D not sure if they will work.

They will work just fine.

C-R-T wrote: ↑Thu Jan 13, 2022 3:56 pm

breakbeatscientist wrote: ↑Wed Jan 12, 2022 10:14 pm Does anyone know which tantalum capacitors will work for C6, C11, and C12? I know the value is 100uF and package is 2312 but that's all the info I have. I found these https://www.mouser.com/ProductDetail/Ky ... 2HcA%3D%3D not sure if they will work.

They will work just fine.

Thank you.