Page 1 of 1
Addon Board - Lights Color
Posted: Tue Mar 09, 2021 4:07 pm
by max1602
Just one stupid question:
Are the lights supposed to be green and red, while the mister is running?
Re: Addon Board - Lights Color
Posted: Tue Mar 09, 2021 9:44 pm
by MAPPY
Yellow only "runs" when accessing the drive
Re: Addon Board - Lights Color
Posted: Wed Mar 10, 2021 1:23 pm
by max1602
How can I disable them?
Re: Addon Board - Lights Color
Posted: Sat Mar 27, 2021 6:29 pm
by Nat
max1602 wrote: ↑Wed Mar 10, 2021 1:23 pm
How can I disable them?
If you have the analog IO board v6.1 you can cut this trace on the underside of the circuit board, this will disable all three coloured status LED's to enable them again you will need to bridge the trace again.
On the boards I build, I just cut the trace and install a 2 pin header on the top side of the PCB and add a jumper cap, this allows for quick and simple enable/disable of your IO board status LEDs when needed.
- io-v6-1-board-disable-LEDs.png (250.11 KiB) Viewed 3219 times
Re: Addon Board - Lights Color
Posted: Thu Apr 01, 2021 1:13 pm
by chanunnaki
Nat wrote: ↑Sat Mar 27, 2021 6:29 pm
max1602 wrote: ↑Wed Mar 10, 2021 1:23 pm
How can I disable them?
If you have the analog IO board v6.1 you can cut this trace on the underside of the circuit board, this will disable all three coloured status LED's to enable them again you will need to bridge the trace again.
On the boards I build, I just cut the trace and install a 2 pin header on the top side of the PCB and add a jumper cap, this allows for quick and simple enable/disable of your IO board status LEDs when needed.
io-v6-1-board-disable-LEDs.png
I just discovered this little feature of your board. Much appreciated!