Hi, I searched here in the forum and the old forum atari, but i did not find the mod made in version 6.0 of the IO board to run the genesis controls in SNAC.
If someone could show me exact location and what it takes to make the mod. My I/O board bought in 2019 with MisterAddons and I'm wanting to use SNAC on it without having to buy a new board.
Help I/O Board v6.0 Mod for SNAC for Genesis Controller
-
Xbytez
- Site Admin
- Posts: 471
- Joined: Wed May 20, 2020 3:36 pm
- Has thanked: 215 times
- Been thanked: 791 times
Re: Help I/O Board v6.0 Mod for SNAC for Genesis Controller
I found a couple of examples on the internet of the modification for the v6.0 IO board. You just need two pieces of wire and a 100 ohm resistor, connect wires and resistor as shown in the images and cut the tracks on the PCB.
- image1.jpg (1.13 MiB) Viewed 1984 times
- image0.jpg (122.24 KiB) Viewed 1984 times
