Page 1 of 1
Script to Test Connection Speed (Up and Down)?
Posted: Sat Dec 17, 2022 7:12 pm
by pbsk8
So, I have been trying today to use update all script but it doesnt run at all, gets tuck on loading script screen. Nothing downloads.
If I run SAM or wallpapers script, they work fine. My mister also shows the ip address, so there is connection.
Just to make sure it has internet connection and at what speed, is there a script I can run to test this?
Re: Script to Test Connection Speed (Up and Down)?
Posted: Sat Dec 17, 2022 10:15 pm
by theypsilon
Do you have a RTC board add-on installed on your MiSTer?
Re: Script to Test Connection Speed (Up and Down)?
Posted: Wed Dec 27, 2023 6:43 pm
by Zxquad
Hi, I have the same question ans yes I have a RTC clock on my Mister 
Re: Script to Test Connection Speed (Up and Down)?
Posted: Wed Dec 27, 2023 8:41 pm
by Bas
Iperf on your local network could rule out MiSTer itself.
Re: Script to Test Connection Speed (Up and Down)?
Posted: Thu Dec 28, 2023 1:40 pm
by FPGA64
With an RTC if its not functioning the Mister will have the wrong day/time. Update_all requires a correctly set date to function. You should always wait for either the Mister to gte its time either from the RTC or the Internet before running update_all