MiSTer FPGA Forum

Hi All,

Xain'd Sleena does not display on my 31khz monitor, i have tried both of them, I can also hear it playing, I have messed around with the video setting but I get a garbled mess on the screen.

Can it not display on 31hz at 640 x 480 ?

Xain'd Sleena does display correctly via HDMI but garbled via VGA 640x 480

Hi all,

I have removed the rom and MRA file, hit update all, and the new download still does not play, I can hear it but the screen is black with lines down the side.

I have my Mister set to Forced Scandouble and set to 604x480

any ideas on this?

Bump

I have put another Mister in my second arcade cab a Sega Net City with a 31khz monitor running 640 x 480 and again Xain'd Sleena still run blind with a black screen with some lines down the right hand side.

Can this game run at 640x480 ?

anyone, thanks any advice ( :

Have you tried both versions?

Both versions work on my 31khz VGA CRT monitor. OSD: 1264x948, 94.96Mhz, 61.6Hz

Ok, It must be me, I can hear it running ... thx

Giddygoon wrote: ↑Fri May 19, 2023 7:27 am

Bump

I have put another Mister in my second arcade cab a Sega Net City with a 31khz monitor running 640 x 480 and again Xain'd Sleena still run blind with a black screen with some lines down the right hand side.

Can this game run at 640x480 ?

anyone, thanks any advice ( :

Same for me, both versions. Plays blind just as you described on my end.

Same for me, both versions. Plays blind just as you described on my end.

I not going mad then, thank you, I was starting to think it was a unique situation with my set-up, all my other games are running at 640x 480 at 60hz no probs.

I have played with all the video settings but still no picture ) :

If that's the original Net City, or some other arcade multi-sync monitor, it's possible it will have some quirks with particular games on MiSTer.

You can try my attached mister.ini, but I'm using a bog-standard PC VGA monitor so it might make no difference on your setup.

Can also try settings from this thread.

I just run the core on my VGA CRT. Xain'd runs fine with my default setup that uses the vga_scaler function with vscale_mode=4 and a video_mode conforming to my monitor specifications.

It seems that the scandoubler function has not been included in the core. Maybe it is because of the non-standard timings of that board, I cannot say for sure. If you want to run it on a 31KHz display, you will need to use vga_scaler.

Hi there, thx for the ini Zip, yeah I am running my original Sega Net City cab with only a 31khz monitor wit forced_scandoubler=1

Maybe thats why ( It seems that the scandoubler function has not been included in the core )

I will play around with some customer settings just for that games and add it to my ini settings e.g [Xain'd Sleena] etc

Thanks again

UPDATE :

I have just set-up my 15khz CRT cab with a Mister and ran Xain'd Sleena and there it is, no problems, working full display ... so it is a 31khz 640 x480 issue, forced_scandoubler not supported at this stage